Do the low speed wipers operate when the low speed setting is selected?
Yes | GO to F2 |
|---|---|
No | GO to Pinpoint Test B |
F2 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) B10AD:02 OR B10AD:08
Using a diagnostic scan tool, carry out the SCCM self-test.
Are any Diagnostic Trouble Codes (DTCs) present?
Yes | For DTC B10AD:02 or B10AD:08, GO to F11 For all other Diagnostic Trouble Codes (DTCs), REFER to the SCCM DTC Chart in this section. |
|---|---|
No | GO to F3 |
F3 VERIFY THE RAIN SENSITIVE WIPER FEATURE IS ENABLED IN THE VEHICLE MESSAGE CENTER
Access the vehicle settings in the message center using the steering wheel controls. Check the rain sensitive feature setting.
Is the rain sensitive feature enabled?
Yes | GO to F4 |
|---|---|
No | ENABLE the rain sensitive feature. INFORM the customer how to enable/disable the rain sensitive feature. |
F4 CHECK THE INPUT FROM THE WIPER/WASHER SWITCH
Using a diagnostic scan tool, monitor the following SCCM wiper/washer switch Parameter Identifications (PIDs):
F_WIP_INT_D1 F_WIP_INT_D2 F_WIP_INT_D3 F_WIP_INT_D4 F_WIP_INT_D5 F_WIP_INT_D6
Cycle the wiper/washer switch from off through each of the auto/intermittent sensitivity settings.
Do the Parameter Identifications (PIDs) correspond correctly with each setting selection?
Yes | GO to F5 |
|---|---|
No | INSTALL a new wiper/washer switch. REFER to: Steering Column Multifunction Switch RH (211-05 Steering Wheel and Column Electrical Components, Removal and Installation). TEST the system for normal operation. If the concern is still present, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) (211-05 Steering Wheel and Column Electrical Components, Removal and Installation). |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.