Does the rain sensor remain adhered to the windshield?
Yes | ATTACH the retaining clips. GO to F10 |
|---|---|
No | The sensor gel-type lens is missing or damaged. INSTALL a new rain sensor. REFER to: Rain Sensor (501-16 Wipers and Washers, Removal and Installation). |
F10 INSPECT THE RAIN SENSOR MOUNTING AREA
NOTE: The rain sensor gel-type lens can be damaged or contaminated during rain sensor removal, rain sensor bracket separation or incorrect installation.
From the outside of the vehicle, inspect the area of the windshield glass where the rain sensor is mounted. The rain sensor contact area should appear black, with no bubbles, air pockets or contaminants between the windshield glass and the rain sensor.
Does the rain sensor contact area appear black, with no bubbles, air pockets or contaminants between the windshield glass and the rain sensor?
Yes | GO to F11 |
|---|---|
No | REMOVE the rain sensor. REFER to: Rain Sensor (501-16 Wipers and Washers, Removal and Installation). CLEAN the mating surfaces between the windshield glass and the rain sensor. INSTALL the rain sensor correctly. TEST the system for normal operation. If the concern is still present, INSTALL a new windshield wiper motor. REFER to: Windshield Wiper Motor - LHD (501-16 Wipers and Washers, Removal and Installation). |
F11 CHECK THE RAIN SENSOR VOLTAGE SUPPLY CIRCUIT FOR AN OPEN
Ignition OFF. Disconnect Rain Sensor C914. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C914-1 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to F12 |
|---|---|
No | VERIFY the BJB fuse 72 (5A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams manual to identify the possible cause of the circuit short. |
F12 CHECK THE RAIN SENSOR GROUND CIRCUIT FOR AN OPEN
Measure:
Click to display connectors
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.