Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C914-1 | C914-3 |
Is the voltage greater than 11 volts?
Yes | GO to F13 |
|---|---|
No | REPAIR the circuit. |
F13 CHECK THE LIN (LOCAL INTERCONNECT NETWORK) CIRCUIT FOR AN OPEN
Ignition OFF. Disconnect SCCM C226A. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C914-2 | C226A-8 |
Is the resistance less than 3 ohms?
Yes | GO to F14 |
|---|---|
No | REPAIR the circuit. |
F14 CHECK FOR CORRECT SCCM (STEERING COLUMN CONTROL MODULE) OPERATION
Disconnect and inspect all the SCCM connectors. Repair:
corrosion (install new connector or terminal - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect all the SCCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) (211-05 Steering Wheel and Column Electrical Components, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
The Windshield Wipers Do Not Park At The Correct Position
Normal Operation and Fault Conditions
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.