No | GO to F6 |
|---|
F6 CHECK THE ELECTRICAL CONNECTORS
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may cause damage to the connector.
Ignition OFF. Disconnect Moveable Roof Control Module A (MRCMA) C4830. Disconnect Moveable Roof Control Module B (MRCMB) C4831. Disconnect GWM C2431. Disconnect BCM C2280G. Using a good light source, inspect each connector for the following:
corrosion - install new connector or terminal and clean the module pins damaged or bent pins - install new terminals or pins pushed-out pins - install new pins as necessary
Using a suitable mating terminal, check the following connector terminals for deformed or enlarged contacts:
C4830-9 C4830-10 C4831-9 C4831-10 C2431-19 C2431-20 C2431-22 C2431-23 C2280G-9 C2280G-10
Are all the connectors free of corrosion, pushed-out pins and deformed or enlarged contacts?
Yes | The system is operating correctly at this time. The DTC may have been set due to high network traffic, a loose connector, a corroded connector or an intermittent fault condition. ADDRESS the root cause of any connector or pin issues. |
|---|---|
No | REPAIR the affected connector. Refer to Wiring Diagrams Cell 5 for schematic and connector information. |
U0142:00
Refer to Wiring Diagrams Cell 103 for schematic and connector information.
Normal Operation and Fault Conditions
When the convertible top is opened, the BCMB sends an "open" request to the rear window smart motors. Once the windows are open, the smart motors send a reply to the BCMB. The BCMB then sends a message to the Moveable Roof Control Module A (MRCMA) over the MS-CAN. If the Moveable Roof Control Module A (MRCMA) does not receive this message within a certain time frame, the module sets a DTC. For information on the messages sent to the Moveable Roof Control Module A (MRCMA) by the BCMB, refer to the Network Message Chart. REFER to: Convertible Top - System Operation and Component Description (501-18 Convertible Top, Description and Operation).
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.