Yes | GO to A13 |
|---|---|
No | REPAIR the affected circuit. Refer to Wiring Diagrams Cell 5 for schematic and connector information. GO to A16 |
A13 CHECK THE PASSENGER SIDE RESTRAINTS SENSOR 2 DTC (DIAGNOSTIC TROUBLE CODE) FOR A FAULT STATUS CHANGE (NO OPERATION INDICATED)
NOTE: This pinpoint test step attempts to change the fault reported by the RCM by inducing a different fault condition. If the fault reported changes, this indicates the RCM is functioning correctly and is not the source of the fault.
Connect RCM C310A and C310B. Connect a fused jumper wire:
Click to display connectors
Lead 1 | Measurement / Action | Lead 2 |
|---|---|---|
C3212-1 | C3212-2 |
Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System, General Procedures). Ignition ON. Using a diagnostic scan tool, perform RCM self-test.
Did the DTC change from B1419:93 to B1414:11 and B1419:11 and, if equipped, B1427:11 and B14EB:11?
Yes | REMOVE the fused jumper wire and INSTALL a new RH B-pillar side impact sensor. REFER to: B-Pillar Side Impact Sensor (501-20B Supplemental Restraint System, Removal and Installation). GO to A16 |
|---|---|
No | REMOVE the fused jumper wire and GO to A14 |
A14 CONFIRM THE RCM (RESTRAINTS CONTROL MODULE) FAULT
NOTE: Make sure all SRS components and the RCM electrical connectors are connected before carrying out the self-test. If not, Diagnostic Trouble Codes (DTCs) will be recorded.
Ignition OFF. Depower the SRS. REFER to: Supplemental Restraint System (SRS) Depowering (501-20B Supplemental Restraint System, General Procedures). Prior to reconnecting any previously disconnected SRS component:
inspect connector(s) (including any inline connectors) for pushed-out, loose or spread terminals and loose or frayed wire connections at terminals. inspect wire harness for any damage, pinched, cut or pierced wires. inspect RCM C310A and C310B Connector Position Assurance (CPA) lever/lock for correct operation. repair any concerns found. Refer to Wiring Diagrams Cell 5 for schematic and connector information.
Connect RH B-pillar Side Impact Sensor C3212 (if previously disconnected). Connect Driver Front Door Side Impact Sensor C567 (if previously disconnected). Connect RCM C310A and C310B. Repower the SRS. Do not prove out the SRS at this time. REFER to: Supplemental Restraint System (SRS) Repowering (501-20B Supplemental Restraint System,
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.