Vehicle Dynamic Suspension

VDM to correct the failure to retain the configuration data. REFER to: Vehicle Dynamics Control Module (VDM) (204-05 Vehicle Dynamic Suspension, Removal and Installation).

U0415:68

Invalid Data Received from Anti-Lock Brake System (ABS) Control Module: Event Information

This DTC sets if the VDM receives invalid or faulted steering wheel angle information or total brake torque information from the ABS module. Using a diagnostic scan tool, RETRIEVE and DIAGNOSE all ABS module Diagnostic Trouble Codes (DTCs). REFER to: Anti-Lock Brake System (ABS) and Stability Control (206-09 Anti-Lock Brake System (ABS) and Stability Control, Diagnosis and Testing). If the diagnostic scan tool cannot communicate with the ABS module, REFER to: Communications Network (418-00 Module Communications Network) . If there are no Diagnostic Trouble Codes (DTCs) in the ABS module, the DTC may be caused by an intermittent concern. SET the ignition to OFF. DISCONNECT and INSPECT all VDM and ABS module electrical connectors and related in-line connectors for corrosion, bent pins, pushed-out pins and spread terminals. REPAIR as necessary.

U0447:68

Invalid Data Received From Gateway "A": Event Information

This DTC sets if the VDM receives invalid or faulted engine, body or instrument cluster information from the GWM. For additional information on PCM, BCM and IPC messages received by the VDM, REFER to the VDM Network Message Input Chart. REFER to: Vehicle Dynamic Suspension - System Operation and Component Description (204-05 Vehicle Dynamic Suspension, Description and Operation). Using a diagnostic scan tool, RETRIEVE and DIAGNOSE all GWM Diagnostic Trouble Codes (DTCs). REFER to: Communications Network (418-00 Module Communications Network) . If the diagnostic scan tool cannot communicate with the GWM, REFER to: Communications Network (418-00 Module Communications Network) . If there are no Diagnostic Trouble Codes (DTCs) in the GWM, the DTC may be caused by an intermittent concern. SET the ignition to OFF. DISCONNECT and INSPECT all VDM, GWM, PCM, BCM and IPC electrical connectors and related in-line connectors for corrosion, bent pins, pushed-out pins and spread terminals. REPAIR as necessary.

U0452:68

Invalid Data Received from Restraints Control Module: Event Information

This DTC sets if the VDM receives invalid or faulted vehicle yaw rate, lateral acceleration, longitudinal acceleration or roll rate information from the RCM. Using a diagnostic scan tool, RETRIEVE and DIAGNOSE all RCM Diagnostic Trouble Codes (DTCs). REFER to: Airbag Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, Diagnosis and Testing). If the diagnostic scan tool cannot communicate with the RCM, REFER to: Communications Network (418-00 Module Communications Network) . If there are no Diagnostic Trouble Codes (DTCs) in the RCM, the DTC may be caused by an intermittent concern. SET the ignition to OFF and WAIT one minute. DISCONNECT and INSPECT all VDM and RCM electrical connectors and related in-line connectors for corrosion, bent pins, pushed-out pins and spread terminals. REPAIR as necessary.