DTC | Description | Action |
|---|---|---|
C1B14:17 | Sensor Supply Voltage A: Circuit Voltage Above Threshold | GO to Pinpoint Test D |
P0562:16 | System Voltage Low: Circuit Voltage Below Threshold | GO to Pinpoint Test A |
P0563:17 | System Voltage High: Circuit Voltage Above Threshold | GO to Pinpoint Test B |
P0601:52 | Internal Control Module Memory Checksum Error: Not Activated | CHECK the service history for recent service actions related to the VDM. This DTC sets due to incomplete or improper PMI procedures. If there have been recent service actions with the VDM, REPEAT the PMI procedure, FOLLOW all diagnostic scan tool instructions. CARRY OUT the ride height sensor calibration routine, FOLLOW all diagnostic scan tool directions. If there have been no recent service actions, INSTALL a new VDM to correct the failure to retain the configuration data. REFER to: Vehicle Dynamics Control Module (VDM) (204-05 Vehicle Dynamic Suspension, Removal and Installation). |
P1674:48 | Control Module Software Corrupted: Supervision Software Failure | CHECK the service history for recent service actions related to the VDM. This DTC sets due to incomplete or improper PMI procedures. If there have been recent service actions with the VDM, REPEAT the PMI procedure, FOLLOW all diagnostic scan tool instructions. CARRY OUT the ride height sensor calibration routine, FOLLOW all diagnostic scan tool directions. If there have been no recent service actions, INSTALL a new VDM to correct the failure to retain the configuration data. REFER to: Vehicle Dynamics Control Module (VDM) (204-05 Vehicle Dynamic Suspension, Removal and Installation). |
P1794:17 | Battery Voltage Circuit: Circuit Voltage Above Threshold | GO to Pinpoint Test B |
P1794:18 | Battery Voltage Circuit: Circuit Current Below Threshold | GO to Pinpoint Test A |
U0121:00 | Lost Communication with Anti-Lock Brake System (ABS) Control Module: No Sub Type Information | GO to Pinpoint Test F |
U0146:00 | Lost Communication With Gateway "A": No Sub Type Information | GO to Pinpoint Test E |
U0151:00 | Lost Communication with Restraints Control Module: No Sub Type Information | GO to Pinpoint Test G |
U0300:57 Internal Control Module CHECK the service history for recent service actions related to
Software Incompatibility: the VDM. This DTC sets due to incomplete or improper PMI Invalid / Incompatible procedures. Software Component If there have been recent service actions with the VDM, REPEAT
the PMI procedure, FOLLOW all diagnostic scan tool instructions. CARRY OUT the ride height sensor calibration routine, FOLLOW all diagnostic scan tool directions. If there have been no recent service actions, INSTALL a new
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.