Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1668-1 Component Side | C1668-2 Component Side |
For the RH front shock absorber solenoid, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1669-2 Component Side | C1669-1 Component Side |
For the LH rear shock absorber solenoid, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4044-2 Component Side | C4044-1 Component Side |
For the RH rear shock absorber solenoid, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4045-1 Component Side | C4045-2 Component Side |
Is the resistance between 2.8 and 4.5 ohms?
Yes | GO to C7 | |
|---|---|---|
No | INSTALL a new front strut or rear shock absorber. REFER to: Front Strut and Spring Assembly (204-01 Front Suspension, Removal and Installation). REFER to: Rear Shock Absorber (204-02 Rear Suspension, Removal and Installation). | |
C7 VERIFY ALL WIRING CONNECTIONS
Ignition OFF. Disconnect all VDM and shock absorber solenoid related in-line electrical connectors. Using a good light source, inspect all disconnected electrical connectors for the following:
corrosion - install new connector or terminal and clean the module pins damaged or bent pins - install new terminals or pins pushed-out pins - install new pins as necessary spread terminals - install new terminals as necessary
Are the connectors free of corrosion, damaged pins, bent pins, pushed-out pins and spread terminals?
Yes | GO to C8 | |
|---|---|---|
No | REPAIR the connector or terminals. Refer to Wiring Diagrams Cell 5 for schematic and connector information. | |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.