Yes | GO to G6 |
|---|---|
No | The system is operating correctly at this time. The concern may have been due to incorrect parts replacement procedures or incorrect module configuration. |
G6 CHECK FOR DTC (DIAGNOSTIC TROUBLE CODE) U0151:XX SET IN OTHER MODULES
Using a diagnostic scan tool, carry out the self-test for all modules.
Is DTC U0151:xx set in 1 or more modules in addition to the VDM?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new RCM. REFER to: Restraints Control Module (RCM) (501-20B Supplemental Restraint System, Removal and Installation). |
|---|---|
No | GO to G7 |
G7 VERIFY ALL WIRING CONNECTIONS
Ignition OFF. Disconnect all VDM electrical connectors and related in-line electrical connectors. Using a good light source, inspect all disconnected electrical connectors for the following:
corrosion - install new connector or terminal and clean the module pins damaged or bent pins - install new terminals or pins pushed-out pins - install new pins as necessary spread terminals - install new terminals as necessary
Are the connectors free of corrosion, damaged pins, bent pins, pushed-out pins and spread terminals?
Yes | GO to G8 |
|---|---|
No | REPAIR the connector or terminals. Refer to Wiring Diagrams Cell 5 for schematic and connector information. |
G8 CHECK FOR CORRECT VDM (VEHICLE DYNAMICS CONTROL MODULE) OPERATION
Connect all VDM electrical connectors and all related in-line electrical connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new VDM. REFER to: Vehicle Dynamics Control Module (VDM) (204-05 Vehicle Dynamic Suspension, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
Copyright © 2016 Ford Motor Company
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.