Ring Gear Backlash Adjustment — 2016 workshop reference 2692

5. NOTE: If the old differential bearing cups and shims are to be reused, they need to be installed in the same location as removed.

Mark the differential shims. Mark the differential carrier bearing cups.

Ring Gear Backlash Adjustment — original illustration 1, reference 2692Original colors & callouts · Select to enlarge

6. Install the Dial Indicator and special tool. Position the tip of the clutch housing gauge on the inside of the axle housing guide hole. Zero the dial indicator. Use Special Service Tool: 308-021 (T75L-4201-A) Gauge, Clutch Housing. Use the General Equipment: Dial Indicator

Ring Gear Backlash Adjustment — original illustration 2, reference 2692Original colors & callouts · Select to enlarge

7. Install a 12” / 300mm C-Clamp on the axle housing at the 12:00 O'clock and 6:00 O'clock positions. Install 2” x 2” x ¾” blocks of wood between the C-Clamp and the housing to prevent housing cracks. Use the General Equipment: Wooden Block

Source reference 2692

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.