DTC | Description | Action |
|---|---|---|
REFER to: Anti-Lock Brake System (ABS) Module (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). | ||
C0044:8F | Brake Pressure Sensor "A": Erratic | DIAGNOSE DTC C0040:64 before diagnosing this DTC. If DTC C0040:64 is not present, CLEAR the DTC. CYCLE the ignition from ON to OFF and back to ON. REPEAT the self-test. If DTC C0044:8F returns, VERIFY all ABS module-to- HCU fasteners are tightened to their correct torque specifications. If all fasteners are tightened to their correct torque specifications, INSTALL a new ABS module and HCU assembly. REFER to: Hydraulic Control Unit (HCU) (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation). |
C0047:01 | Brake Booster Pressure Sensor: General Electric Failure | GO to Pinpoint Test M |
C0047:26 | Brake Booster Pressure Sensor: Signal Rate of Change Below Threshold | GO to Pinpoint Test M |
C0047:27 | Brake Booster Pressure Sensor: Signal Rate of Change Above Threshold | GO to Pinpoint Test M |
C0051:62 | Steering Wheel Position Sensor: Signal Compare Failure | GO to Pinpoint Test J |
C0051:64 | Steering Wheel Position Sensor: Signal Plausibility Failure | GO to Pinpoint Test J |
C0051:67 | Steering Wheel Position Sensor: Signal Incorrect After Event | GO to Pinpoint Test J |
C0051:85 | Steering Wheel Position Sensor: Signal Above Allowable Range | GO to Pinpoint Test J |
C0061:28 | Lateral Acceleration Sensor: Signal Bias Level Out of Range / Zero Adjustment Failure | GO to Pinpoint Test G |
C0061:2F | Lateral Acceleration Sensor: Signal Erratic | GO to Pinpoint Test G |
C0061:64 | Lateral Acceleration Sensor: Signal Plausibility Failure | GO to Pinpoint Test G |
C0062:28 | Longitudinal Acceleration Sensor: Signal Bias Level Out of Range / Zero Adjustment Failure | GO to Pinpoint Test G |
C0062:54 Longitudinal Acceleration This DTC sets if the stability sensors in the RCM have not been
Sensor: Missing calibrated or the calibration has been lost. CARRY OUT the IVD Calibration Initialization routine, FOLLOW the diagnostic scan tool instructions.
If the module fails the initialization routine, VERIFY the RCM is installed correctly and the fasteners are tightened to specifications. REINSTALL the RCM or INSTALL a new RCM as necessary. REFER to: Restraints Control Module (RCM) (501-20B Supplemental Restraint System, Removal and Installation).
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.