DTC | Description | Action |
|---|---|---|
(DTCs) other than C0072:00. REFER to: Cruise Control (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control, Diagnosis and Testing). If DTC C0072:00 is the only DTC present in the CCM or if DTC C0072:68 is the only DTC present in the ABS module, ALLOW the vehicle to cool down for 30 minutes. CLEAR all ABS module Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If ABS module DTC C0072:68 returns, INSTALL a new CCM. REFER to: Cruise Control Module (CCM) (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control, Removal and Installation). | ||
C1015:08 | Vacuum Supply: Bus Signal / Message Failure | GO to Pinpoint Test M |
C1015:7A | Vacuum Supply: Fluid Leak or Seal Failure | GO to Pinpoint Test R |
C1015:7B | Vacuum Supply: Low Fluid Level | GO to Pinpoint Test R |
C1020:00 | Brake System Fill Not Complete: No Sub-Type Information | This DTC is pre-set in a new ABS module and HCU assembly and can only be cleared when the Brake System Service Bleed is successfully carried out. CARRY OUT the Brake System Service Bleed. REFER to: Brake System Pressure Bleeding (206-00 Brake System - General Information, General Procedures). |
C1109:64 | Vehicle Dynamics Control Switch: Signal Plausibility Failure | This DTC sets in continuous memory and on-demand when the information in the stability-traction control switch message from the FCIM is implausible (does not match other sensor inputs or messages). This indicates a concern with the MS-CAN, HS-CAN2, the GWM or the FCIM. RETRIEVE and DIAGNOSE all GWM and FCIM Diagnostic Trouble Codes (DTCs). For GWM Diagnostic Trouble Codes (DTCs), REFER to: Communications Network (418-00 Module Communications Network, Diagnosis and Testing). For FCIM Diagnostic Trouble Codes (DTCs), REFER to: Information and Entertainment System (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Diagnosis and Testing). REFER to: Information and Entertainment System (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Diagnosis and Testing). |
C1137:64 Reverse Gear Switch: This DTC sets when the reverse gear message sent from the PCM
Signal Plausibility Failure indicates the transmission is in REVERSE when other stability
control inputs received by the ABS module indicate the vehicle is moving forward. VERIFY the reverse lamps operate correctly. If the lamps do not operate correctly, REFER to: Reversing Lamps (417-01 Exterior Lighting, Diagnosis and Testing). If the reverse lamps operate correctly, RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the PCM. REFER to: Electronic Engine Controls (303-14A Electronic Engine Controls - 2.3L EcoBoost (231kW/314PS), Diagnosis and Testing). REFER to: Electronic Engine Controls (303-14B Electronic Engine Controls - 3.7L Duratec (227kW/301PS), Diagnosis and Testing). REFER to: Electronic Engine Controls (303-14C Electronic Engine Controls - 5.0L 32V Ti-VCT/5.0L Ti-VCT V8 (308kW/418PS),
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.