DTC | Description | Action |
|---|---|---|
REFER to: Electronic Engine Controls (303-14A Electronic Engine Controls - 2.3L EcoBoost (231kW/314PS), Diagnosis and Testing). REFER to: Electronic Engine Controls (303-14B Electronic Engine Controls - 3.7L Duratec (227kW/301PS), Diagnosis and Testing). REFER to: Electronic Engine Controls (303-14C Electronic Engine Controls - 5.0L 32V Ti-VCT/5.0L Ti-VCT V8 (308kW/418PS), Diagnosis and Testing). | ||
U0001:88 | High Speed CAN Communication Bus: Bus Off | A HS-CAN fault was present at a point in time. The fault is not currently present since the module is communicating with the diagnostic scan tool. CLEAR the DTC. REPEAT the Network Test with the diagnostic scan tool. VERIFY the integrity of the connectors and wiring. Refer to Wiring Diagrams Cell 14 for schematic and connector information. |
U0100:00 | Lost Communication With ECM / PCM "A": No Sub Type Information | GO to Pinpoint Test I |
U0104:00 | Lost Communication With Cruise Control Module: No Sub Type Information | GO to Pinpoint Test P |
U0131:00 | Lost Communication With Power Steering Control Module: No Sub Type Information | GO to Pinpoint Test Q |
U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test D |
U0151:00 | Lost Communication With Restraints Control Module: No Sub Type Information | GO to Pinpoint Test S |
U0300:51 | Internal Control Module Software Incompatibility: Not Programmed | CHECK vehicle service history for recent service actions related to the ABS module. This DTC sets due to incomplete or improper flash programming procedures. If there have been recent service actions with the ABS module, REPEAT the programming procedure as directed by the diagnostic scan tool. |
U0401:00 | Invalid Data Received From ECM / PCM "A": No Sub Type Information | GO to Pinpoint Test I |
U0405:41 | Invalid Data Received From Cruise Control Module: General Checksum Failure | GO to Pinpoint Test P |
U0405:82 | Invalid Data Received From Cruise Control Module: Alive / Sequence Counter Incorrect / Not Updated | GO to Pinpoint Test P |
U0420:41 | Invalid Data Received From PSCM: General Checksum Failure | GO to Pinpoint Test Q |
U0420:82 | Invalid Data Received From PSCM: Alive / Sequence Counter Incorrect / Not Updated | GO to Pinpoint Test Q |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.