Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C135-6 | Ground | |
C135-7 | Ground |
For the RH rear wheel speed sensor, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C135-10 | Ground | |
C135-11 | Ground |
Is any voltage present?
Yes | REPAIR the circuit. |
|---|---|
No | GO to L6 |
L6 CHECK THE WHEEL SPEED CIRCUITS FOR AN OPEN
Ignition OFF. For the LH rear wheel speed sensor, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C135-6 | C440-2 | |
C135-7 | C440-1 |
For the RH rear wheel speed sensor, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C135-10 | C426-2 | |
C135-11 | C426-1 |
Are the resistances less than 3 ohms?
Yes | GO to L7 |
|---|---|
No | REPAIR the circuit. |
L7 CHECK FOR SHORTED WHEEL SPEED SENSOR CIRCUITS
Ignition OFF. Disconnect ABS module C135 (if not previously disconnected) Disconnect the suspect wheel speed sensor electrical connector (if not previously disconnected). For the LH rear wheel speed sensor, measure:
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.