Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C440-1 | C440-2 |
For the RH rear wheel speed sensor, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C426-1 | C426-2 |
Is the resistance greater 10,000 ohms?
Yes | If DTC C0037:11 or C003A:11 are present, GO to L8 If DTC C0037:15 or C003A:15 are present, GO to L9 |
|---|---|
No | REPAIR the circuit. |
L8 CHECK THE WHEEL SPEED SENSOR CIRCUITS FOR A SHORT TO GROUND
For the LH rear wheel speed sensor, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C135-6 | Ground | |
C135-7 | Ground |
For the RH rear wheel speed sensor, measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C135-10 | Ground | |
C135-11 | Ground |
Are the resistances greater than 10,000 ohms?
Yes | GO to L9 |
|---|---|
No | REPAIR the circuit. |
L9 CHECK THE ABS (ANTI-LOCK BRAKE SYSTEM) MODULE OUTPUT
NOTE: Make sure all test connections are made at the wheel speed sensor before the ignition is set to ON.
NOTE: Use a meter with a min-max feature or recording capabilities to obtain accurate measurements. The ABS module immediately disables the voltage output if the wheel speed sensor is not present.
Ignition OFF. Connect ABS module C135. Connect the meter to the suspect wheel speed sensor electrical connector, harness side.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.