MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Brake System

Anti-Lock Brake System (ABS) and Stability Control

206-09 Anti-Lock Brake System (ABS) and Stability Control

2016 MustangReference 2,996 / 6,619HTML edition
← Chapter contentsProcedure contents

M9 VERIFY ALL WIRING CONNECTIONS

Ignition OFF. Disconnect ABS module C135. Using a good light source, inspect ABS module C135 for the following:

corrosion - install a new connector or terminal and clean module pins damaged or bent pins - install new terminals or pins pushed-out pins - install new pins as necessary spread terminals - install new terminals as necessary

Are the connectors free of corrosion, damaged pins, bent pins, pushed-out pins and spread terminals?

Yes

GO to M10

No

REPAIR the affected connectors or terminals. Refer to Wiring Diagrams Cell 5 for schematic and connector information.

M10 CHECK FOR CORRECT ABS (ANTI-LOCK BRAKE SYSTEM) MODULE OPERATION

Connect ABS module C135. Make sure it seats and latches correctly. Connect brake booster vacuum sensor C1609. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.

Is the concern still present?

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new ABS module. REFER to: Anti-Lock Brake System (ABS) Module (206-09 Anti-Lock Brake System (ABS) and Stability Control, Removal and Installation).

No

The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.

U3002:62

Refer to Wiring Diagrams Cell 42 for schematic and connector information.

Normal Operation and Fault Conditions

When the ignition is in RUN, the ABS module and the PCM share VIN information through the GWM over the HS-CAN1 and the HS-CAN2.

DTC Fault Trigger Conditions

DTC

Description

Fault Trigger Conditions

U3002:62 Vehicle Identification Number:

Signal Compare Failure

This DTC indicates the VIN message sent by the PCM over the HS-CAN1 does not match the VIN stored in the ABS module.

Possible Causes

Module configuration (ABS and PCM)

Source reference 2996

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.