Steering Gear

211-02 Power Steering 2016 Mustang

Removal and Installation Procedure revision date: 07/23/2015

Base Part Number: 3D080

Special Tool(s) / General Equipment

Steering Gear — original illustration 1, reference 3306Original colors & callouts · Select to enlarge	204-816 Rack Holding Tool TKIT-2014D-FL_ROW TKIT-2014D-ROW2
Boot Clamp Pliers
Oil Drain Equipment

Materials

Name	Specification
Premium Long-Life Grease XG-1-E1	ESA-M1C75-B
Motorcraft® SAE 5W-30 Premium Synthetic Blend Motor Oil (U.S.) XO-5W30-QSP (U.S.)	WSS-M2C946-A

Removal

All vehicles

1. If installing a new steering gear, connect the scan tool and upload the module configuration information from the PSCM. Refer to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation).

2. NOTICE: Make sure to minimize damage to sealer foam and avoid pulling apart dash seal brackets

from retainer pins. Excessive damage may allow engine noise, fumes, air or water to enter the passenger compartment.

1. Remove the steering column dash seal nuts.

2. Loosen the dash seal.

3. Hand start the dash seal nuts.

Source reference 3306

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.