Engine
Base Part Number: 6L084
Special Tool(s) / General Equipment
303-F047 Lifting Bracket, Engine | |
303-F072 Support Bar, Engine | |
Magnetic Socket | |
Floor Crane | |
Oil Drain Equipment | |
Trolley Jack | |
Wooden Block | |
6-Speed Automatic Transmission - 6R80/6-Speed Manual Transmission - MT82
1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
2. Release the fuel system pressure. Refer to: Fuel System Pressure Release (310-00C Fuel System - General Information - 5.0L 32V Ti-VCT/5.0L Ti-VCT V8 (308kW/418PS), General Procedures).
3. Disconnect the battery ground and positive cables. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
4. Drain the engine cooling system. Refer to: Cooling System Draining and Vacuum Filling (303-03C Engine Cooling - 5.0L 32V Ti-VCT/5.0L Ti-VCT V8 (308kW/418PS), General Procedures).
5. NOTICE: Make sure to minimize damage to sealer foam and avoid pulling apart dash seal brackets
from retainer pins. Excessive damage may allow engine noise, fumes, air or water to enter the passenger compartment.
1. Remove the steering column dash seal nuts.
2. Loosen the dash seal.
3. Hand start the dash seal nuts.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.