Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
Forward collision warning message request | CCM | Input used to display the forward collision warning messages. |
Fuel fill inlet message display | PCM | Input used to display the check fuel fill inlet message. |
Fuel flow volume display | PCM | Input used to display the Average Fuel Economy (AFE)/DTE. |
GPS compass direction (without touchscreen audio) | GPSM | Input used to display the vehicle compass heading. |
Hill start assist status | ABS module | Input used to control the hill start assist not available message. |
Ignition key type | BCM | Input used to display the Average Fuel Economy (AFE)/DTE. |
Ignition status | BCM | Input used for the following: To provide ignition RUN, START and ACC states. To display the transmission not in park warning message. To display the odometer. |
Immobilizer message display | BCM | Input used to display the PATS, passive entry and key programming messages. |
Lock system message request | BCM | Input used to display the child lock, key battery low and security mode messages. |
Luggage compartment lid ajar | BCM | Input used to control the door ajar RTT and the luggage compartment lid ajar message center warning message. |
Odometer count | PCM | Input used to display the Average Fuel Economy (AFE)/DTE and odometer. |
Oil pressure warning indicator request | PCM | Input used to control the low oil pressure RTT and the low oil pressure message center warning message. |
Parking aid fault status | PAM | Input used to display the check parking aid message. |
Parking aid rear status | PAM | Input used to display the parking aid on/off status message. |
Parking brake status | BCM | Input used to display the parking brake applied warning message. |
Passenger door ajar status | BCM | Input used to control the door ajar RTT and the passenger door ajar message center warning message. |
Perimeter alarm chime request | BCM | Input used to display the start vehicle to stop alarm message. |
Power shed level request | BCM | Input used to display the load shed messages. |
Powertrain drive mode | PCM | Input used to control the following drive mode Reconfigurable Telltales (RTT's): Drag strip (SVT) Launch control (SVT) Normal drive Sport Snow/wet (non-SVT) Track (non-SVT) Weather (SVT) |
Remote start status | BCM | Input used to display the remote start messages. |
Seat memory command | DSM | Input used to display the memory seat operational messages. |
Side obstacle detect status-left | SODL | Input used to control the Blind Spot Monitoring (BLIS®) off RTT and message display. |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.