ABS Module Network Input Messages
Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
Steering angle sensor data | PSCM | The ABS module uses the steering angle sensor data to generate the steering angle message that is sent to the BCM to support the active guideline feature. |
APIM Network Input Messages
Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
Rear park aid camera status | BCM | Used to display the current settings for the visual park aid alert and zoom level. |
Parking aid range to object | PAM | Used to generate the visual highlights in the zone where an object is detected by the parking aid system. |
Gear position | PCM | Used to enable and disable the video display when reverse gear is selected. |
Vehicle speed | PCM | When the video delay feature is turned on, this message is used to turn the camera display off after the vehicle speed exceeds a preset threshold. |
FCDIM Module Network Input Messages
Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
Gear position | PCM | Used to enable and disable the video display when reverse gear is selected. |
Parking aid range to object | PAM | Used to generate the visual highlights in the zone where an object is detected by the parking aid system. |
Image Display - Vehicles Equipped With An 8 in (203 mm) Touchscreen
NOTE: The luggage compartment lid must remain closed for correct operation of the parking aid camera system.
The rear park aid camera image is displayed by the FDIM when the reverse gear is selected. To determine the selector lever (automatic transmission) or gearshit lever (manual transmission) position and enable the rear park aid camera display, the PCM sends the gear position message over the HS-CAN1 to the GWM. The GWM then sends the message to the APIM on the HS-CAN3.
The BCM provides power to the rear view camera when the ignition is in the ON position. The BCM rear parking aid camera stand by mode is used to turn off the camera video signal when the vehicle speed is 10 mph (16 km/h) or greater or turn on the camera video signal when the vehicle speed is 8 mph (13 km/h) or lower. The camera generates a video signal any time it's on regardless of the current configuration. If the camera is not configured properly, some features may be inoperative. When the rear parking aid camera is on, the image signal is sent from the camera on shielded twisted pair wires to the APIM, which displays the image on the FDIM.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.