Is the concern still present?
Yes | GO to B2 |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by dirt or debris on the camera lens or intermittent electromagnetic interference from an outside source. |
B2 CHECK THE VOLTAGE TO THE CAMERA
Ignition OFF. Disconnect: Rear Parking Aid Camera C4357. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4357-1 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to B3 |
|---|---|
No | INSPECT BJB fuse 66 (5A). If the fuse is OK, repair the circuit for high resistence. If the fuse is not OK, REFER to the Wiring Diagrams manual to identify the possible causes of the short circuit. |
B3 CHECK THE CAMERA GROUND CIRCUIT
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4357-1 | C4357-5 |
Is the voltage greater than 11 volts?
Yes | For vehicles equipped with an 8 in (203mm) touchscreen display, GO to B4 For vehicles equipped with a 4.2 in (107 mm) display, GO to B8 |
|---|---|
No | REPAIR the camera shield ground circuit. |
B4 CHECK THE VIDEO SIGNAL CIRCUITS FOR A SHORT TO VOLTAGE
Ignition OFF. Disconnect: APIM C2342. Ignition ON. Measure:
Click to display connectors
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.