Parking Aid — 2016 workshop reference 4009

Positive Lead	Measurement / Action	Negative Lead
C4357-3		C4357-5
C4357-4		C4357-5

Are the resistances greater than 10,000 ohms?

Yes	GO to B11
No	REPAIR the circuit in question.

B11 CHECK VIDEO SIGNAL CIRCUITS FOR AN OPEN

Measure:

Click to display connectors

Positive Lead	Measurement / Action	Negative Lead
C4357-3		C2123-12
C4357-4		C2123-6

Are the resistances less than 3 ohms?

Yes	GO to B12
No	REPAIR the circuit in question.

B12 CHECK FOR CORRECT PARKING AID CAMERA OPERATION

Ignition OFF. Disconnect and inspect the rear parking aid camera connector. Repair:

corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary

Reconnect the rear parking aid camera connector. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new rear parking aid camera. REFER to: Rear Parking Aid Camera (413-13B Parking Aid - Vehicles With: Parking Aid Camera, Removal and Installation). TEST the system for normal operation. If the concern is still present, for vehicles equipped with a 4.2 in (107 mm) display, GO to B13 For vehicles equipped with an 8 in (203mm) touchscreen display, GO to B14
No	The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new rear parking aid camera. REFER to: Rear Parking Aid Camera (413-13B Parking Aid - Vehicles With: Parking Aid Camera, Removal and Installation).

TEST the system for normal operation. If the concern is still present, for vehicles equipped with a 4.2 in (107 mm) display, GO to B13 For vehicles equipped with an 8 in (203mm) touchscreen display, GO to B14

The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.

Source reference 4009

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.