Are any APIM Diagnostic Trouble Codes (DTCs) recorded?
Yes | REFER to: Information and Entertainment System (415-00 Information and Entertainment System - General Information - Vehicles With: Touchscreen Display) . |
|---|---|
No | GO to C8 |
C8 CHECK FOR CORRECT APIM (SYNC MODULE) OPERATION
Ignition OFF. Disconnect and inspect the APIM connector. Repair:
Corrosion (clean module pins or install new connectors or terminals) Damaged or bent pins (install new terminals or pins) Pushed-out pins (install new pins as necessary)
Reconnect the APIM connector. Make sure it seats and latches correctly. Wait at least 2 minutes for the APIM to re-initialize. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, PERFORM the APIM Hardware Test. Click here to access Guided Routine (APIM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
The Fixed Or Active Guidelines Are Inoperative
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description (413-13B Parking Aid - Vehicles With: Parking Aid Camera, Description and Operation).
Possible Sources
Rear parking aid camera Luggage compartment lid position data concern LIN concern BCM ABS module concern PSCM concern (active guidelines only)
Visual Inspection and Diagnostic Pre-Checks
Verify the luggage compartment lid is fully closed. Verify the inoperative feature is enabled in the settings menu. Refer to the Owner's Literature. For active guideline concerns, verify the concern was not caused by the steering wheel being in the straight ahead position. Active guidelines are not displayed unless the steering wheel is rotated. If the rear video camera is not configured after replacement, some video functions will be inoperative. Verify the rear video camera configuration using the diagnostic scan tool.
NOTE: If the battery has been disconnected or discharged, or a module is disconnected or replaced, the active
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.