No | The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
|---|
D9 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Ignition OFF. Disconnect and inspect all BCM connectors. Repair:
corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary
Reconnect all BCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, Click here to access Guided Routine (BCM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
The Video Delay Is Inoperative
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description (413-13B Parking Aid - Vehicles With: Parking Aid Camera, Description and Operation).
Possible Sources
Communication network concern Gear input concern FCDIM concern (vehicles with 4.2 in (107 mm) display) APIM concern (vehicles with 8 in (203 mm) touchscreen display)
Visual Inspection and Diagnostic Pre-Checks
Verify the video delay feature is enabled in the settings menu. Refer to the Owner's Literature.
PINPOINT TEST E : THE VIDEO DELAY IS INOPERATIVE
E1 PERFORM A NETWORK TEST
Ignition ON. Using a diagnostic scan tool, perform a network test.
Do all modules pass the network test?
Yes | GO to E2 |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.