Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
E6 CHECK FOR CORRECT APIM (SYNC MODULE) OPERATION
Ignition OFF. Disconnect and inspect the APIM connector. Repair:
Corrosion (clean module pins or install new connectors or terminals) Damaged or bent pins (install new terminals or pins) Pushed-out pins (install new pins as necessary)
Reconnect the APIM connector. Make sure it seats and latches correctly. Wait at least 2 minutes for the APIM to re-initialize. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, PERFORM the APIM Hardware Test. Click here to access Guided Routine (APIM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
The Manual Zoom Is Inoperative
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description (413-13B Parking Aid - Vehicles With: Parking Aid Camera, Description and Operation).
Possible Sources
Network communication concern Rear parking aid camera LIN concern APIM concern (vehicles equipped 8 in (203 mm) touchscreen display) FCDIM concern (vehicles equipped wih 4.2 in (107 mm) display)
Visual Inspection and Diagnostic Pre-Checks
If the rear video camera is not configured after replacement, some video functions will be inoperative. Verify the rear video camera configuration using the diagnostic scan tool.
PINPOINT TEST F : THE MANUAL ZOOM IS INOPERATIVE
F1 PERFORM A NETWORK TEST
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.