Is the concern still present?

Ignition OFF. Disconnect and inspect the FCIM connectors. Repair:

Corrosion (clean module pins or install new connectors or terminals) Damaged or bent pins (install new terminals or pins) Pushed-out pins (install new pins as necessary)

Reconnect the FCIM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.

Yes	CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new FCIM. REFER to: Front Controls Interface Module (FCIM) (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation).
No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new FCIM. REFER to: Front Controls Interface Module (FCIM) (415-00B Information and Entertainment System - General Information - Vehicles With: Touchscreen Display, Removal and Installation).

The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

The RH Upper Steering Wheel Switches Are Inoperative Or Do Not Operate Correctly

Refer to Wiring Diagrams Cell 131 for schematic and connector information.

Normal Operation and Fault Conditions

REFER to: Information and Entertainment System (415-00B) . See Steering Wheel Switch Function and Steering Wheel Switches.

DTC Fault Trigger Conditions

DTC Description Fault Trigger Conditions DTC Type B1380:09 Steering Wheel Right Switch Set by the SCCM when the RH lower or RH upper Continuous and Pack: Component Failure steering wheel switch is stuck for more than 2 on-demand minutes during normal operation. B1380:11 Steering Wheel Right Switch Set by the SCCM when a short to ground is Continuous and Pack: Circuit Short To Ground detected on the RH lower or RH upper steering on-demand wheel switch circuits. B1380:17 Steering Wheel Right Switch Set by the SCCM when a short to voltage is Continuous and Pack: Circuit Voltage Above detected on the RH lower or RH upper steering on-demand Threshold wheel switch circuits.

Original table alignment retained · Scroll horizontally if needed

Possible Sources

Steering wheel switch Wiring, terminals, or connectors Clockspring SCCM

Source reference 4471

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.