AM6 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
Ignition OFF. Disconnect and inspect all the BCM connectors. Repair:
Corrosion (clean module pins or install new connectors or terminals) Damaged or bent pins (install new terminals or pins) Pushed-out pins (install new pins as necessary)
Reconnect the BCM connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, PERFORM the BCM Guided Routine. Click here to access Guided Routine (BCM). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
U0142:00
Normal Operation and Fault Conditions
REFER to: Information and Entertainment System - System Operation and Component Description (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Description and Operation). See Network Message Chart.
DTC Fault Trigger Conditions
Description | Fault Trigger Conditions | DTC Type |
|---|---|---|
U0142:00 Lost Communication With Body Control Module "B": No Sub Type Information | Set by the ACM, audio DSP module, and DACMC when network messages are missing from the BCMB for more than 5 seconds with the ignition in RUN. | Continuous |
DTC
Possible Source
BCMB
PINPOINT TEST AN : U0142:00
AN1 VERIFY THE CUSTOMER'S CONCERN
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.