MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

HN: Turbocharger System HN: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 5,176 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

• For TCBY,

• Measure the resistance between:

( + ) TCBY Valve Connector, Component

Side

( - ) TCBY Valve Connector, Component

Side

TCBY

VPWR

• For TCBY2,

• Measure the resistance between:

( + ) TCBY2 Valve Connector, Component

Side

( - ) TCBY2 Valve Connector, Component

Side

TCBY2 - Pin 2

VPWR - Pin 1

• For turbocharger wastegate regulating valve solenoid,

• Measure the resistance between:

( + ) Turbocharger Wastegate Regulating Valve Solenoid Connector, Component Side

( - ) Turbocharger Wastegate Regulating Valve Solenoid Connector, Component Side

TCWRVS

VPWR

Are the resistances between 5 - 60 ohms?

Yes

No

GO to HN10 .

INSTALL a new component. REFER to the Workshop Manual Section 303-14, Electronic Engine Controls.

Clear the PCM DTCs. REPEAT the self-test.

HN10 CHECK THE WIRING HARNESS

Note: This step applies to multiple components, only measure the circuits that apply to the vehicle and component being diagnosed.

• Ignition OFF.

• PCM connector connected.

• For TCBY or TCBY2,

• Suspect TCBY Solenoid connector connected.

• Ignition ON, engine OFF.

• Access the PCM and monitor the TURBO_BP1_STAT (MODE) PID.

• Access the PCM and monitor the TURBO_BP2_STAT (MODE) PID.

• For the turbocharger wastegate regulating valve solenoid,

• Turbocharger Wastegate Regulating Valve Solenoid connector connected.

• Ignition ON, engine OFF.

• Access the PCM and monitor the TWGATE_STAT (MODE) PID.

• For wastegate vacuum sensor,

• Wastegate Vacuum Sensor connector connected.

• Ignition ON, engine OFF.

• Access the PCM and monitor the WGATE_PRES_F (MODE) PID.

• While observing the PID, wiggle, shake, and bend small sections of the wiring harness while working from the component to the PCM.

Source reference 5176

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.