MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

JB: Secondary Ignition (COP) JB: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 5,237 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

JB13 CHECK THE SPARK PLUGS

Note: To determine the condition of the spark plugs, refer to the Workshop Manual Section 303- 00, Engine and carry out the Spark Plug Inspection.

• Ignition OFF.

• Remove and inspect the spark plugs for damage, wear, carbon tracking or deposits and correct spark plug gap.

Are the plugs OK?

Yes

No

GO to JB14 .

REPAIR the spark plugs. ADJUST the gap or INSTALL a new spark plug as necessary. REFER to the Workshop Manual Section 303- 07, Engine Ignition.

Clear the PCM DTCs. REPEAT the self-test.

JB14 CHECK THE SPARK PLUG RESISTANCE

• Measure the spark plug resistance.

Is the resistance between 2,000 ohms and 12,000 ohms at a room temperature of 25°C (77°F)?

Yes

No

GO to JB15 .

INSTALL a new spark plug. REFER to the Workshop Manual Section 303-07, Engine Ignition.

Clear the PCM DTCs. REPEAT the self-test.

JB15 TEST DIRECTION FOR SYMPTOM CHARTS

Were you directed to this pinpoint test from Section 3?

Yes

No

RETURN to Section 3 , Symptom Charts for further direction.

GO to JB16 .

JB16 TEST DIRECTION FOR PINPOINT TEST HD

Were you directed to this pinpoint test from pinpoint test step HD8?

Yes

No

GO to HD9 .

The concern is intermittent.

GO to Pinpoint Test Z .

Source reference 5237

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.