MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

JC: Secondary Ignition (Coil Pack) JC: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 5,239 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

2016 PCED Gasoline Engines SECTION 5: Pinpoint Tests

Procedure revision date: 11/23/2015

JC: Secondary Ignition (Coil Pack)

JC: Introduction

JC1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS)

Are DTCs P0300, P0301, P0302, P0303 or P0304?

Yes

No

For DTC P0300, GO to JC2 .

For all others, GO to JC10 .

For symptoms without DTCs, GO to JC2 .

For all others, RETURN to Section 3 , Symptom Charts for further direction.

JC2 CYLINDER POWER BALANCE TEST

Note: The IDS test referenced in this step may not be available on all vehicles. Follow the YES answer if the IDS test is not available.

• Carry out the Power Balance Test. Refer to the instruction manual provided by the scan tool manufacturer.

Are all cylinders contributing correctly during the power balance test?

Yes

No

GO to JC3 .

For a coil pack using an engine analyzer, GO to JC4 .

For a coil pack not using an engine analyzer, GO to JC10 .

JC3 VISUAL INSPECTION OF THE IGNITION SYSTEM

• Visually inspect the engine compartment to make sure all coils and spark plug wires are correctly and securely connected.

• Examine all wiring harnesses and connectors for damaged, burned or overheated insulation and loose or broken conditions.

• Visually inspect the interior and exterior surfaces of the coil tower for damage or carbon tracking.

• Visually inspect the interior and exterior surfaces of the spark plug wire boots for damage or carbon tracking.

• Make sure the vehicle battery is in good condition and all accessories are turned off.

Is a concern present?

Yes

No

REPAIR as necessary.

Clear the PCM DTCs. REPEAT the self-test.

For a coil pack using an engine analyzer, GO to JC4 .

Source reference 5239

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.