MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Powertrain Control-Emissions Diagnosis

QB: Keep Alive Power (KAPWR) QB: Introduction

Powertrain Control-Emissions Diagnosis

Ford gasoline diagnostic supplementReference 5,327 / 6,619HTML edition
← Chapter contentsProcedure contents

Vehicle applicability: This diagnostic supplement covers multiple Ford vehicles and engines. Follow the application named in the source below. Some references apply to vehicles other than Mustang.

2016 PCED Gasoline Engines SECTION 5: Pinpoint Tests

Procedure revision date: 11/23/2015

QB: Keep Alive Power (KAPWR)

QB: Introduction

QB1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS)

Note: The DTC P2610 may set after a PCM reprogramming. If this DTC is retrieved after a PCM reprogramming, disregard this DTC.

• Carry out a visual inspection.

• Record the DTCs.

• Record the freeze frame data.

• Clear the PCM DTCs.

• Carry out the PCM self-test.

Are DTCs P0603, P1633 or P2610 present?

Yes

No

For DTC P2610, GO to QB6 .

For all others, GO to QB2 .

Unable to duplicate the condition. CHECK for a loose connection, and damaged or corroded pins. WIGGLE the harness attempting to recreate the concern. REPAIR as necessary. REFER to Section 3, GO to Pinpoint Test QT , if a driveability concern exists.

Clear the PCM DTCs. REPEAT the self-test.

QB2 CHECK THE 12-VOLT BATTERY TERMINALS

Note: If the KAPWR is interrupted to the PCM, a DTC can be generated on the first power-up.

Note: If DTC P0603 occurred right after or during an unsuccessful reprogramming of the PCM, clear the DTCs and repeat the PCM self-test. If DTC P0603 is retrieved again, continue with this pinpoint test.

• Inspect the 12 volt battery cables for loose connections and for corrosion.

Are the 12 volt battery terminal connections in good condition?

Yes

No

GO to QB3 .

REPAIR as necessary.

Clear the PCM DTCs. REPEAT the self-test.

QB3 INSPECT THE ENGINE COMPARTMENT FOR CORRECT WIRE ROUTING

• Inspect the electronic engine control (EEC) system wiring for correct wire routing.

• Check the wiring routing to establish if any of the electrical connectors are being stressed due to incorrectly routed wiring. If necessary re-route and secure the wiring.

• Visually inspect the wiring and connectors.

Source reference 5327

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.