Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C481-2 | C2280C-12 |
Is the resistance less than 3 ohms?
Yes | GO to A9 |
|---|---|
No | REPAIR the circuit. |
A9 CHECK THE REAR SIDE MARKER AND LICENSE PLATE LAMPS SUPPLY CIRCUIT FOR A SHORT TO GROUND
Disconnect: RH Rear Side Marker Lamp C482. Disconnect: LH License Plate Lamp C4046A and RH License Plate Lamp C4046B. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C481-2 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to A26 |
|---|---|
No | REPAIR the circuit. After the repair: If no Diagnostic Trouble Codes (DTCs) are present, TEST the system for normal operation. If DTC U1000:00 is present, CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test (required to enable the lamp output driver if DTC U1000:00 is present). If DTC U3000:49 is present, Click here to access Guided Routine (BCM). |
A10 CHECK FOR VOLTAGE TO THE FRONT SIDE MARKER LAMP
Place the headlamp switch in the OFF position. Ignition OFF. Disconnect: Inoperative LH Front Side Marker Lamp C1127 or RH Front Side Marker Lamp C1126. Ignition ON. Place the headlamp switch in the PARKING LAMPS position. Measure:
Click to display connectors
LH Front Side Marker Lamp
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1127-2 | Ground |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.