Interior Lighting

B1175:01

Driver Door Ajar Switch: General Electrical Failure

If the courtesy lamps are always on, GO to Pinpoint Test D If the courtesy lamps are inoperative, GO to Pinpoint Test A

B1176:01

Passenger Door Ajar Switch: General Electrical Failure

If the courtesy lamps are always on, GO to Pinpoint Test D If the courtesy lamps are inoperative, GO to Pinpoint Test A

B12C2:11

Puddle Lamp: Circuit Short To Ground

GO to Pinpoint Test C

B12C2:15

Puddle Lamp: Circuit Short To Battery or Open

GO to Pinpoint Test C

B1313:11

Interior Lighting Output: Circuit Short To Ground

GO to Pinpoint Test B

B1313:15

Interior Lighting Output: Circuit Short To Battery or Open

GO to Pinpoint Test B

U1000:00

Solid State Driver Protection Active -Driver Disabled: No Sub Type Information

The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test.

U3000:49

Control Module: Internal Electronic Failure

The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is

corrected, Click here to access Guided Routine (BCM).

All other BCM Diagnostic Trouble Codes (DTCs)

-

REFER to: Body Control Module (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing).