DTC | Description | Action |
|---|---|---|
U3000:49 | Control Module: Internal Electronic Failure | The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the Body Control Module B (BCMB) can withstand. The cause of the excessive current draw MUST be corrected before a new Body Control Module B (BCMB) is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, INSTALL a new Body Control Module B (BCMB). REFER to: Body Control Module B (BCMB) (419-10 Multifunction Electronic Modules, Removal and Installation). |
All other Body Control Module B (BCMB) Diagnostic Trouble Codes (DTCs) | - | REFER to: Body Control Module B (BCMB) (419-10 Multifunction Electronic Modules, Diagnosis and Testing). |
Symptom Chart(s)
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Symptom Chart: Interior Lighting
Symptom Chart
Condition | Possible Sources | Actions |
|---|---|---|
A module does not respond to the scan tool | Fuse Wiring, terminals or connectors Module | REFER to: Communications Network (418-00 Module Communications Network) . |
The courtesy lamps do not illuminate with a door open | Refer to the Pinpoint Test | GO to Pinpoint Test A |
One or both interior overhead courtesy lamps are inoperative or the interior courtesy lamps stay on continuously | Refer to the Pinpoint Test | If one or both map lamps are also inoperative, GO to Pinpoint Test E If the map lamps operate correctly, GO to Pinpoint Test B |
One or both pony projection lamps are inoperative or always on | Refer to the Pinpoint Test | GO to Pinpoint Test C |
All the courtesy lamps stay on continuously | Refer to the Pinpoint Test | GO to Pinpoint Test D |
One or more demand lamps are inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test E |
The luggage compartment lamp is inoperative or on continuously | Refer to the Pinpoint Test | GO to Pinpoint Test F |
The battery saver does not deactivate after time-out | Refer to the Pinpoint Test | GO to Pinpoint Test G |
The ambient lighting is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test H |
The ambient lighting does not cycle through all color combinations | Refer to the Pinpoint Test | GO to Pinpoint Test I |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.