DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
|---|---|---|
B1313:11 | Interior Lighting Output: Circuit Short To Ground | A continuous memory and on-demand DTC that sets when the BCM detects a short to ground from the interior lighting output circuit. |
B1313:15 Interior Lighting Output: Circuit Short To Battery or Open | A continuous memory and on-demand DTC that sets when the BCM detects an open or short to voltage from the interior lighting output circuit. | |
U1000:00 Solid State Driver Protection Active -Driver Disabled: No Sub Type Information | This DTC sets when the BCM has temporarily shut down the output driver. The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected, the Diagnostic Trouble Codes (DTCs) have been cleared and a successful self-test is run. | |
U3000:49 Control Module: Internal Electronic Failure | This DTC sets when the BCM has permanently shut down the output driver. The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. CORRECT the cause of the excessive current draw before installing a new BCM. |
Possible Sources
Wiring, terminals or connectors Bulb Interior lamp BCM
PINPOINT TEST B : ONE OR BOTH INTERIOR OVERHEAD COURTESY LAMPS ARE INOPERATIVE OR
THE INTERIOR COURTESY LAMPS STAY ON CONTINUOUSLY
B1 CHECK THE COURTESY LAMP OPERATION WITH THE DOORS CLOSED
Close the doors. Press the RKE LOCK button.
Do the interior courtesy lamps turn off?
Yes | If one interior overhead courtesy lamp is inoperative, INSTALL a new courtesy lamp bulb. If the lamp is still inoperative, INSTALL a new overhead console. REFER to: Overhead Console (501-12 Instrument Panel and Console, Removal and Installation). If both interior overhead courtesy lamps are inoperative, GO to B2 |
|---|---|
No | GO to B5 |
B2 CHECK FOR VOLTAGE TO THE INTERIOR OVERHEAD COURTESY LAMPS
Disconnect: Dome Lamp C901. Open a door. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C901-4 | Ground |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.