Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new PDM. REFER to: Passenger Door Module (PDM) (419-10 Multifunction Electronic Modules, Removal and Installation). | |
|---|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. | |
The Side Obstacle Detection Control Module LH (SOD-L) Does Not Respond To The Diagnostic Scan Tool
Refer to Wiring Diagrams Cell 14 for schematic and connector information.
Refer to Wiring Diagrams Cell 136 for schematic and connector information.
Normal Operation and Fault Conditions
The SODL communicates on the MS-CAN and communicates with the diagnostic scan tool through the HS-CAN2. Diagnostic messages are sent/received through the HS-CAN2 circuits at the DLC, and are translated through the GWM to the MS-CAN.
Possible Sources
Fuse Wiring, terminals and connector SODL
Visual Inspection and Diagnostic Pre-checks
Verify BJB fuse 66 (5A) is OK.
PINPOINT TEST W : THE SIDE OBSTACLE DETECTION CONTROL MODULE LH (SOD-L) DOES NOT
RESPOND TO THE DIAGNOSTIC SCAN TOOL
W1 CHECK THE SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) VOLTAGE SUPPLY CIRCUITS FOR AN OPEN
Ignition OFF. Disconnect: SODL C4369. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4369-5 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to W2 |
|---|
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.