No | VERIFY the BJB fuse 66 (5A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams manual to identify the possible causes of the circuit short. |
|---|
W2 CHECK THE SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) GROUND CIRCUIT FOR AN OPEN
Ignition OFF. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4369-8 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to W3 |
|---|---|
No | REPAIR the circuit. |
W3 CHECK THE MS-CAN (MEDIUM SPEED-CONTROLLER AREA NETWORK) CIRCUITS BETWEEN THE SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) AND THE GWM (GATEWAY MODULE A) FOR AN OPEN
Disconnect: GWM C2431. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C4369-6 | C2431-23 | |
C4369-7 | C2431-22 |
Are the resistances less than 3 ohms?
Yes | GO to W4 |
|---|---|
No | REPAIR the circuit in question. |
W4 CHECK FOR CORRECT SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) OPERATION
Ignition OFF. Disconnect and inspect the SODL connector and related in-line connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the SODL connector and related in-line connectors. Make sure they seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.