AC5 CHECK THE MS-CAN (MEDIUM SPEED-CONTROLLER AREA NETWORK) TERMINATION RESISTANCE, COMPONENT SIDE
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2431-23 (component side) | C2431-22 (component side) |
Is the resistance between 108 and 132 ohms?
Yes | GO to AC6 |
|---|---|
No | GO to AC9 |
AC6 CHECK THE HS-CAN3 (HIGH SPEED-CONTROLLER AREA NETWORK 3) TERMINATION RESISTANCE, COMPONENT SIDE
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2431-16 (component side) | C2431-15 (component side) |
Is the resistance between 108 and 132 ohms?
Yes | GO to AC7 |
|---|---|
No | GO to AC9 |
AC7 CHECK THE GWM (GATEWAY MODULE A) VOLTAGE SUPPLY CIRCUITS FOR AN OPEN
Connect negative battery cable. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C2431-13 | Ground | |
C2431-24 | Ground |
Is the voltage greater than 11 volts?
Yes | GO to AC8 |
|---|---|
No | VERIFY the BCM fuse 13 (7.5A) or fuse 15 (10A) is OK. If OK, REPAIR the circuit. If not OK, REFER to the Wiring Diagrams manual to identify the possible causes of the circuit short. |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.