Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C251-3 | Ground | |
C251-11 | Ground |
Are the resistances greater than 1,000 ohms?
Yes | GO to AE4 |
|---|---|
No | GO to AE11 |
AE4 CHECK THE HS-CAN2 (HIGH SPEED-CONTROLLER AREA NETWORK 2) (+) AND HS-CAN2 (HIGH SPEED-CONTROLLER AREA NETWORK 2) (-) CIRCUITS FOR A SHORT TO VOLTAGE
Connect negative battery cable. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C251-3 | Ground | |
C251-11 | Ground |
Is the voltage greater than 6 volts on either circuit?
Yes | REPAIR the circuit in question. |
|---|---|
No | GO to AE12 |
AE5 CHECK THE HS-CAN2 (HIGH SPEED-CONTROLLER AREA NETWORK 2) TERMINATION RESISTOR
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C251-3 | C251-11 |
Is the resistance between 108 and 132 ohms?
Yes | GO to AE6 |
|---|---|
No | GO to AE8 |
AE6 CHECK THE HS-CAN2 (HIGH SPEED-CONTROLLER AREA NETWORK 2) TERMINATION RESISTOR WITH THE GWM (GATEWAY MODULE A) DISCONNECTED
Source reference 5938
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.