PINPOINT TEST D : P0833 OR P170A
D1 CHECK THE CPP (CLUTCH PEDAL POSITION) SWITCH (CPP_TOP) PARAMETER IDENTIFICATION (PID)
Ignition ON. Using a diagnostic scan tool, view PCM Parameter Identifications (PIDs). Monitor the PCM CPP_TOP PID while pressing and releasing the clutch pedal.
Does the PID value read "YES" with the clutch pedal pressed AND "NO" with the clutch pedal released?
Yes | GO to D4 |
|---|---|
No | If PID always read "NO", GO to Pinpoint Test C If PID always reads "YES", GO to D2 |
D2 CHECK THE CPP (CLUTCH PEDAL POSITION) TOP OF TRAVEL SWITCH SIGNAL CIRCUIT FOR A SHORT TO GROUND
Ignition OFF. Disconnect PCM C1551B (2.3L), C1381B (3.7L) or C175B (5.0L). Measure:
Click to display connectors
2.3L
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1551B-6 | Ground |
Click to display connectors
3.7L
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C1381B-8 | Ground |
Click to display connectors
5.0L
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C175B-8 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to D5 |
|---|---|
No | GO to D3 |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.