A1 VERIFY THE CCM (CRUISE CONTROL MODULE) AND HUD (HEAD UP DISPLAY) MODULE PASS THE NETWORK TEST
Do both the CCM and the HUD module pass the network test?
Yes | GO to A2 |
|---|---|
No | REFER to: Communications Network (418-00 Module Communications Network) . |
A2 CHECK THE DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE CONTINUOUS AND ON-DEMAND HUD (HEAD UP DISPLAY) MODULE SELF-TESTS
Using a diagnostic scan tool, perform the HUD module self-test.
Are any HUD module Diagnostic Trouble Codes (DTCs) recorded?
Yes | REFER to DTC Charts in this section. |
|---|---|
No | GO to A3 |
A3 CHECK THE CCM (CRUISE CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
Using a diagnostic scan tool, perform the CCM self-tests.
Are any CCM Diagnostic Trouble Codes (DTCs) recorded?
Yes | If DTC C1132:4B is recorded, GO to Pinpoint Test E For all other CCM Diagnostic Trouble Codes (DTCs), REFER to: Cruise Control (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control, Diagnosis and Testing). |
|---|---|
No | GO to A4 |
A4 CHECK THE MESSAGE CENTER FOR CORRECT OPERATION
Check the IPC message center for correct operation.
Does the message center operate correctly?
Yes | GO to A5 |
|---|---|
No | REFER to: Instrumentation, Message Center and Warning Chimes (413-01 Instrumentation, Message Center and Warning Chimes) . |
A5 CHECK FOR CORRECT HUD (HEAD UP DISPLAY) OPERATION
Ignition OFF. Disconnect and inspect HUD module connector. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the HUD module connector. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.