MAMUSTANG ATLASTHE ENTHUSIAST'S REFERENCE

2016 workshop · Electronic Feature Group

Collision Warning and Collision Avoidance System

419-03C Collision Warning and Collision Avoidance System

2016 MustangReference 6,135 / 6,619HTML edition
← Chapter contentsProcedure contents

Using a diagnostic scan tool, perform a HUD module self-test.

Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes

REFER to DTC Charts in this section.

No

GO to B4

B4 CHECK THE DTCS FROM THE CCM (CRUISE CONTROL MODULE) SELF-TEST

Using a diagnostic scan tool, perform a CCM self-test.

Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes

If DTC C1132:4B is recorded, GO to Pinpoint Test E For all other CCM Diagnostic Trouble Codes (DTCs), REFER to: Cruise Control (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control, Diagnosis and Testing).

No

GO to B5

B5 CHECK FOR CORRECT HUD (HEAD UP DISPLAY) OPERATION

Ignition OFF. Disconnect and inspect HUD module connector. Repair:

corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary

Reconnect the HUD module connector. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.

Is the concern still present?

Yes

CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module (419-03C Collision Warning and Collision Avoidance System, Removal and Installation).

No

The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.

U0104:00

Refer to Wiring Diagrams Cell 136 for schematic and connector information.

Normal Operation and Fault Conditions

REFER to: Collision Warning and Collision Avoidance System - System Operation and Component Description (419-03C Collision Warning and Collision Avoidance System, Description and Operation).

DTC Fault Trigger Conditions

Source reference 6135

2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.