Yes | For DTC U3003:16, GO to Pinpoint Test G For DTC U3003:1C, GO to Pinpoint Test H |
|---|---|
No | GO to C5 |
C5 RECHECK THE HUD (HEAD UP DISPLAY) MODULE DIAGNOSTIC TROUBLE CODES (DTCS)
Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs). Repeat the HUD module self-test.
Is DTC U0104:00 still present?
Yes | INSTALL a new CCM. REFER to: Cruise Control Module (CCM) (419-03B Cruise Control - Vehicles With: Adaptive Cruise Control, Removal and Installation). CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the HUD module self-test. If DTC U0104:00 is still present, INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module (419-03C Collision Warning and Collision Avoidance System, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition. |
U0146:00
Refer to Wiring Diagrams Cell 136 for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Collision Warning and Collision Avoidance System - System Operation and Component Description (419-03C Collision Warning and Collision Avoidance System, Description and Operation).
DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
|---|---|---|
U0146:00 Lost Communication With Gateway "A": No Sub Type Information | Sets in the HUD module if data messages received from the GWM over the HS-CAN2 are missing. |
Possible Sources
HUD module GWM
PINPOINT TEST D : U0146:00
D1 VERIFY THE CUSTOMER CONCERN
Ignition ON. Verify there is an observable concern.
Is an observable symptom present?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.