E2 CHECK FOR HUD (HEAD UP DISPLAY) MODULE LED (LIGHT EMITTING DIODE) PROVE-OUT TEST
NOTE: Remove the vehicle from any extreme heat source or sunload condition prior to testing the vehicle.
Do the HUD module light emitting diodes (LEDs) illuminate?
Yes | The HUD module Light Emitting Diodes (LEDs) are operating correctly at this time. The concern may have been caused by extreme temperatures. |
|---|---|
No | GO to E3 |
E3 CHECK THE DTCS FROM THE HUD (HEAD UP DISPLAY) MODULE SELF-TEST
Using a diagnostic scan tool, perform the HUD module self-test.
Are any HUD module Diagnostic Trouble Codes (DTCs) recorded?
Yes | REFER to the DTC Chart in this section. |
|---|---|
No | GO to E4 |
E4 CHECK FOR CORRECT HUD (HEAD UP DISPLAY) OPERATION
Ignition OFF. Disconnect and inspect HUD module connector. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the HUD module connector. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module (419-03C Collision Warning and Collision Avoidance System, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
U210A:16 Or U210A:17
Refer to Wiring Diagrams Cell 136 for schematic and connector information.
Normal Operation and Fault Conditions
DTC Fault Trigger Conditions
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.