DTC | Description | Fault Trigger Conditions |
|---|---|---|
U210A:16 Temperature Sensor: Circuit Voltage Below Threshold | Sets in continuous memory in the HUD module when the internal temperature sensor circuit is below the lowest valid temperature value. | |
U210A:17 Temperature Sensor: Circuit Voltage Above Threshold | Sets in continuous memory in the HUD module when the internal temperature sensor circuit is above the highest valid temperature value. |
Possible Sources
HUD module
PINPOINT TEST F : U210A:16 OR U210A:17
F1 CHECK FOR HUD (HEAD UP DISPLAY) MODULE DIAGNOSTIC TROUBLE CODES (DTCS)
Ignition OFF. Ignition ON. Using a diagnostic scan tool, clear the HUD module Continuous Memory Diagnostic Trouble Codes (CMDTCs). Retrieve Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Is DTC U210A:16 or U210A:17 recorded?
Yes | GO to F2 |
|---|---|
No | The system is operating normally at this time. The DTC may have been set previously due to an internal intermittent fault with the temperature sensor circuit. |
F2 CHECK FOR CORRECT HUD (HEAD UP DISPLAY) OPERATION
Ignition OFF. Disconnect and inspect HUD module connector. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the HUD module connector. Make sure it seats and latches correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new HUD. REFER to: Head Up Display (HUD) Module (419-03C Collision Warning and Collision Avoidance System, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues. |
U3003:16
Refer to Wiring Diagrams Cell 136 for schematic and connector information.
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.