Is DTC U0146:00 set in other modules?
Yes | INSTALL a new GWM. REFER to: Gateway Module A (GWM) (418-00 Module Communications Network, Removal and Installation). |
|---|---|
No | INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module (419-03C Collision Warning and Collision Avoidance System, Removal and Installation). |
C1132:4B
Refer to Wiring Diagrams Cell 136 for schematic and connector information.
Normal Operation and Fault Conditions
The HUD module is designed with a temperature sensor internal to the module. Due to extremely hot weather conditions, the temperature sensor circuit allows the HUD module to disable under high temperature conditions, which could damage the HUD module Light Emitting Diodes (LEDs). The HUD module is designed with a LED prove-out test. Upon each ignition cycle when the ignition switch is in RUN, the Light Emitting Diodes (LEDs) illuminate for a period of time indicating the HUD module is functional.
DTC Fault Trigger Conditions
DTC | Description | Fault Trigger Conditions |
|---|---|---|
C1132:4B Head Up Display: Over Temperature | Sets as a continuous memory and on-demand DTC in the CCM if the HUD module is over-temperature. |
Possible Sources
HUD module
PINPOINT TEST E : C1132:4B
E1 CHECK THE COMMUNICATION NETWORK
Ignition ON. Using a diagnostic scan tool, perform the network test.
Does the HUD module pass the network test?
Yes | GO to E2 |
|---|---|
No | REFER to: Communications Network (418-00 Module Communications Network) . |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.