No | GO to D10 |
|---|
D10 CHECK THE EXTERIOR MIRROR GROUND CIRCUIT FOR AN OPEN
Disconnect: LH Exterior Mirror C520 (LH LED concern). Disconnect: RH Exterior Mirror C626 (RH LED concern). Measure:
Click to display connectors
LH Exterior Mirror LED
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C520-7 | Ground |
Click to display connectors
RH Exterior Mirror LED
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C626-7 | Ground |
Is the resistance less than 3 ohms?
Yes | GO to D13 |
|---|---|
No | REPAIR the circuit. |
D11 CHECK FOR CORRECT SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) OPERATION
Ignition OFF. Disconnect and inspect all SODL connector and related in-line connectors. Repair:
corrosion (install new connector or terminals – clean module pins) damaged or bent pins – install new terminals/pins pushed-out pins – install new pins as necessary
Reconnect the SODL connector and related in-line connectors. Make sure all connectors seat and latch correctly. Operate the system and determine if the concern is still present.
Is the concern still present?
Yes | CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If a TSB exists for this concern, DISCONTINUE this test and FOLLOW TSB instructions. If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new SODL. REFER to: Side Obstacle Detection Control Module (419-04 Side and Rear Vision, Removal and Installation). |
|---|---|
No | The system is operating correctly at this time. Concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues. |
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.