Are the resistances greater than 10,000 ohms?
Yes | GO to C10 |
|---|---|
No | REPAIR the affected circuit. |
C10 CHECK THE POSITION SENSOR CIRCUITS FOR AN OPEN BETWEEN THE LH (LEFT-HAND) EXTERIOR MIRROR AND THE DDM (DRIVER DOOR MODULE)
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C520-12 | C501B-15 | |
C520-10 | C501B-6 | |
C520-9 | C501B-5 | |
C520-8 | C501B-16 |
Are the resistances less than 3 ohms?
Yes | GO to C11 |
|---|---|
No | REPAIR the affected circuit. |
C11 CHECK THE MIRROR POSITION SENSOR REFERENCE VOLTAGE AT THE LH (LEFT-HAND) EXTERIOR MIRROR
Connect: DDM C501B. Ignition ON. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C520-9 | C520-12 |
Is the voltage approximately 5 volts?
Yes | GO to C12 |
|---|---|
No | GO to C23 |
C12 CHECK THE DDM (DRIVER DOOR MODULE) DIAGNOSTIC TROUBLE CODES (DTCS) WITH THE LH (LEFT-HAND) EXTERIOR MIRROR DISCONNECTED
Using a diagnostic scan tool, clear the DDM Diagnostic Trouble Codes (DTCs). Perform the DDM self-test.
Is DTC B1C13:15 or B1C14:15 present?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.