Is any voltage present?
Yes | REPAIR the circuit. |
|---|---|
No | GO to C23 |
C21 CHECK THE VERTICAL MOTOR CIRCUIT FOR A SHORT TO GROUND AT THE LH (LEFT-HAND) EXTERIOR MIRROR
Ignition OFF. Disconnect: DDM C501B. Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C520-1 | Ground |
Is the resistance greater than 10,000 ohms?
Yes | GO to C22 |
|---|---|
No | REPAIR the circuit. |
C22 CHECK THE VERTICAL MOTOR CIRCUIT FOR AN OPEN BETWEEN THE LH (LEFT-HAND) EXTERIOR MIRROR AND THE DDM (DRIVER DOOR MODULE)
Measure:
Click to display connectors
Positive Lead | Measurement / Action | Negative Lead |
|---|---|---|
C520-1 | C501B-7 |
Is the resistance less than 3 ohms?
Yes | GO to C23 |
|---|---|
No | REPAIR the circuit. |
C23 CHECK FOR CORRECT DDM (DRIVER DOOR MODULE) OPERATION
Disconnect and inspect all DDM connectors. Repair:
corrosion (install new connector or terminals - clean module pins) damaged or bent pins - install new terminals/pins pushed-out pins - install new pins as necessary
Reconnect the DDM connectors and all previously disconnected exterior mirror system connectors. Make sure they seat and latch correctly. Operate the system to determine if the concern is still present.
Is the concern still present?
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.