B1C12:15 Passenger Up/Down Mirror Motor: Circuit Short To Battery Or Open | This continuous and on-demand DTC sets if the PDM detects a lower than expected current draw when voltage is applied to the vertical mirror motor circuit. | |
B1C15:11 | Passenger Up/Down Mirror Motor Feedback: Circuit Short To Ground | This continuous and on-demand DTC sets if the PDM detects a short to ground on the vertical position feedback circuit. |
B1C15:15 Passenger Up/Down Mirror Motor Feedback: Circuit Short To Battery Or Open | This continuous and on-demand DTC sets if the PDM detects a short to voltage or open on the vertical position feedback circuit. | |
B1C16:11 | Passenger Left/Right Mirror Motor Feedback: Circuit Short To Ground | This continuous and on-demand DTC sets if the PDM detects a short to ground on the horizontal position feedback circuit. |
B1C16:15 Passenger Left/Right Mirror Motor Feedback: Circuit Short To Battery Or Open | This continuous and on-demand DTC sets if the PDM detects a short to voltage or open on the horizontal position feedback circuit. | |
C1B15:11 | Sensor Supply Voltage B: Circuit Short To Ground | This continuous and on-demand DTC sets if the PDM detects a short to ground on the RH exterior mirror position sensor voltage supply circuit. |
C1B15:15 Sensor Supply Voltage B: Circuit Short To Battery or Open | This continuous and on-demand DTC sets if the PDM detects a short to voltage or open on the RH exterior mirror position sensor voltage supply circuit. |
Possible Causes
Wiring, terminals or connectors Exterior mirror control switch (integral to the front door window control switch) Exterior mirror PDM
Visual Inspection and Diagnostic Pre-Checks
Inspect BCM fuse 26 (30A).
PINPOINT TEST D : THE RH (RIGHT-HAND) EXTERIOR MIRROR IS INOPERATIVE OR DOES NOT
OPERATE IN ONE OR MORE DIRECTION(S) (WITH MEMORY MIRRORS)
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may cause damage to the connector. Use only Rotunda Flex Probes (NUD105- R025D)
NOTICE: The following step uses a test lamp to simulate normal circuit loads. To avoid connector terminal damage, use the Rotunda Flex Probe kit for the test lamp probe connection to the vehicle. Do not use the test lamp probe directly on any connector.
D1 PERFORM A NETWORK TEST
Ignition ON. Using a diagnostic scan tool, perform a network test.
Do the DDM and PDM pass the network test?
Yes | GO to D2 | |
|---|---|---|
No | REFER to: Communications Network (418-00 Module Communications Network) . | |
D2 CHECK THE PDM (PASSENGER DOOR MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
2016 Mustang workshop publication supplied to Mustang Atlas. Original technical text and illustrations; HTML formatting by Mustang Atlas. Source page numbering is retained for traceability. Follow the configuration, revision, warnings, and cross-references in the material. About this edition.